minicom configuration

由于系统默认的com设备节点名为modem，所以要用minicom连接rs232的时候需要修改一下设备名，修改方法见下面的列表。

minicom

minicom: WARNING: configuration file not found, using defaults

Device /dev/modem access failed: No such file or directory.

I am using fedora 6 , kernel ver–2.6.18

I think it is not installed in my system ….from where to get it and and how to configure and install it…

on unix configure the minicom using command :

1. minicom -s, in the configuration select save setup as dfl

2. Set serial port baud rate e.g. 115200,8N1 , and serial device as /dev/ttyS0

3. Save the configuration and run the minicom .

4. If error comes then you can set hardware flow control to no.