CCNA实验2.VLAN
2014-06-14 20:54
363 查看
一.
二.配置主VTP上的信息
sw2上配置为domain server,sw1上配置为domain client,sw2上增加vlan并命名和添加描述conf t
vtp domain corp
vtp mode server
vtp password xxx
SW-2(config)#vlan 10 SW-2(config-vlan)#? VLAN configuration commands:
exit Apply changes, bump revision number, and exit mode
name Ascii name of the VLAN
no Negate a command or set its defaults
SW-2(config-vlan)#name HR SW-2(config-vlan)#interface vlan 10 SW-2(config-if)#? Interface configuration commands: arp Set arp type (arpa, probe, snap) or timeout description Interface specific description exit Exit from interface configuration mode ip Interface Internet Protocol config commands ipv6 IPv6 interface subcommands no Negate a command or set its defaults shutdown Shutdown the selected interface standby HSRP interface configuration commands 查看: 三.两交换机之间配置trunk
int f0/24switchport mode trunk
四.交换机上端口分别加入vlan
conf tint f0/1
switchport access vlan 10
查看vlan下的端口
show vlan id xx
相关文章推荐
- CCNA实验—VLAN
- CCNA学习笔记之一---VLAN实验组网
- CCNA实验之---单臂路由实现VLAN间路由
- CCNA实验之---三层交换机实现VLAN间路由
- CCNA实验四:VLAN VTP VLAN间路由实验
- Packet Tracer 5.0建构CCNA实验攻略(2)——配置VLAN
- ccna学习指南中文第五版中的vlan路由实验
- Packet Tracer 5.0建构CCNA实验攻略(11)――路由器实现Vlan间通信
- CCNA实验解析——VLAN间的路由的配置
- Packet Tracer 5.0建构CCNA实验攻略(2)——配置VLAN
- CCNA实验之---三层交换机实现VLAN间路由
- Packet Tracer 5.0 构建CCNA实验(2)—— 配置VLAN
- CCNA实验:VLan间路由实验配置 (单臂路由)
- 交换机上VLAN的定义及划分 CiSCO之CCNA篇实验五
- CCNA实验1 交换与vlan
- Packet Tracer 5.0建构CCNA实验攻略--路由器实现Vlan间通信
- ccna-独臂路由VLAN配置实验
- CCNA实验-VLAN间的路由
- Packet Tracer 5.0 构建CCNA实验(3)—— 路由器实现vlan间通信