华为NE5000E与思科GSR12接口配置转换
2013-11-25 13:31
288 查看
思科 | 华为 |
默认封装HDLC(encapsulation ppp) | 默认封装PPP(link-protocol hdlc) |
ip access-group 166 in | traffic-policy acl3166 inbound |
ip route-cache flow sampled input | ip netstream inbound |
load-interval 30 | set flow-stat interval 30 |
dampening | control-flap |
没有 pos framing sdh pos flag s1s0 2 | 加 frame-format sonet |
ip router isis core | isis enable 86 |
isis circuit-type level-2-only | isis circuit-level level-2 |
isis metric 1000 level-2 | isis cost 1000 level-2 |
ip verify unicast source reachable-via any allow-self-ping | ip urpf loose |
相关文章推荐
- 配置交换机端口聚合(思科、华为、锐捷)
- 思科华为三层交换机VLAN间路由配置:
- SpringCloud系列六:Feign接口转换调用服务(Feign 基本使用、Feign 相关配置)
- 华为和思科路由器的互联配置
- C-E3. 配置交换机接口 ❀ C3750-E ❀ 思科 (CISCO) 交换机
- 热备份路由协议中思科HSRP与华为VRRP的配置实例及区别
- 镜像模式解释 及 思科、华为等主流交换机镜像模式配置
- 华为模拟器ipv6接口配置
- 链路聚合定义/Eth-trunk/思科华为配置实例
- 思科与华为设备配置SNMP
- 思科/华为/锐捷/华三四种路由器的配置命令
- 华为设备基于全局的,基于接口的,以及中继DHCP配置和原理
- 思科、华为远程登录配置小结
- 配置交换机端口聚合(思科、华为、锐捷)
- 思科/华为IS-IS协议基本配置命令(华为eNSP模拟器)
- 华为CE12800接口默认配置
- (思科、锐捷、华为)交换机配置snmp(学习笔记)
- 华为USG配置案例_允许trust区域ping通trust区域中的接口
- 华为 思科 配置
- 华为防火墙地址转换配置