Question Analysis of the Crusher Workflow

It is understood that the problems of the crusher at work occurred, we should pay attention to the following points:
A. When the Crusher is working,
we should pay attention whether the nesting is smooth, which is an important
part of the machines work properly. At the design time, although we made some
efforts, the two palatal plate the maximum angle less than 12 degrees, but the
question still exist in the use of nesting poor. Later on, we changed the shape
of the palate, plus an adjustment of two palatal pull angle adjustment skids,
solve this problem better.

2. In order to facilitate the exclusive regulation of the discharge
port size,we adopt the pad adjustment. Turn the adjusting bolt top overruns
board, and then add or win adjust Horn, to achieve the required angle between
the moving palate plate and palate. Cycle and then adjust the bolt, so that the
adjusting screw from the force in the course of their work, breaking force the
body to pass through the horns.

3. Due to the poor working conditions of the crusher, the dust is
serious, the bearing is particularly easy to wear, so we should properly deal
with the problem of bearing seal.we adopt the multi-layer sealing method, and
often pay attention to the lubrication work, in order to maintain its good
working condition.

4. According to the requirements, the crusher is equipped with
separation sieve to separate the material after crushing block and powder,
without prior screening. Material block can be used directly.

Mining
crusher is the crushing machinery whose content is more than 50% of the
total,the row compound particles is larger than three millimeters. Which is
invented by British Heng. according to the size of feeding and nesting
granularity,The crushing operations is often divided into the rough
crushing,middle crushing and fine crushing. The crusher is widely used in many
sectors of mining, smelting, building material, highway, railway, water
conservancy and chemical industry.The general used equipments are jaw crusher, impact
crusher, impact crusher, compound crusher, single-stage hammer crusher, vertical
crusher, gyratory crusher, cone crusher, roll
crusher machine, double roll crusher, two-in-one crusher and so on.
After a
year of the crusher use, the machine efficiency is high, the labor intensity is
low. The Inadequacies are: the noisy is big when the machine is working, the
dust higher. mineral processing equipment is essential, so the careful operation
is needed.