ip unnumbered
2009-07-21 01:48
155 查看
ip unnumbered
To enable IP processing on a serial interface without assigning an explicit IP address to the interface, use the ip unnumbered[/b] interface configuration command. [/b]To disable the IP processing on the interface, use the no [/b]form of this command.ip unnumbered[/b] type number
no ip unnumbered[/b] type number
Syntax Description
type number | Type and number of another interface on which the router has an assigned IP address. It cannot be another unnumbered interface. |
Default
Disabled
Command Mode
Interface configuration
Usage Guidelines
Whenever the unnumbered interface generates a packet (for example, fora routing update), it uses the address of the specified interface as
the source address of the IP packet. It also uses the address of the
specified interface in determining which routing processes are sending
updates over the unnumbered interface. Restrictions include the
following:
•
Serial
interfaces using HDLC, PPP, LAPB, and Frame Relay encapsulations, as
well as SLIP and tunnel interfaces can be unnumbered. It is not
possible to use this interface configuration command with X.25 or SMDS
interfaces.
•
You cannot use the ping[/b]
EXEC command to determine whether the interface is up, because the
interface has no address. Simple Network Management Protocol (SNMP) can
be used to remotely monitor interface status.
•
You cannot netboot a runnable image over an unnumbered serial interface.
•
You cannot support IP security options on an unnumbered interface.
The interface you specify by the type and number arguments must be enabled (listed as "up" in the show interfaces [/b]command display).
If you
are configuring IS-IS across a serial line, you should configure the
serial interfaces as unnumbered. This allows you to conform with RFC
1195, which states that IP addresses are not required on each
interface.
Note
Using
an unnumbered serial line between different major networks (majornets)
requires special care. If at each end of the link there are different
majornets assigned to the interfaces you specified as unnumbered, then
any routing protocol running across the serial line must not advertise
subnet information.
Example
In the following example, the first serial interface is given Ethernet 0's address:interface ethernet 0
ip address 131.108.6.6 255.255.255.0
!
interface serial 0
ip unnumbered ethernet 0
相关文章推荐
- IP Unnumbered
- Understanding and Configuring the ip unnumbered Command
- IP UNNUMBERED
- Ip Unnumbered使用实例
- ip unnumbered interface number
- IP UNNUMBERED
- 关于IP Address Unnumbered的介绍
- Initialization failed for Block pool <registering> (Datanode Uuid unassigned) service to IP1:8020 Invalid volume failure config value: 1
- 无编号IP(IP unnumber)用途
- 什么样的局域网需要IP-MAC绑定?IP-MAC绑定的好处。
- PV/UV/IP
- 为Web网站添加IP过滤功能实践总结(C#)
- Java初学习-unreported exception java.io.IOException; must be caught or declared to be thrown
- 获取本机ip(仅作为知识点记录)
- DSP公司如何利用街道级IP地理定位提升广告投放ROI
- TCP/IP基础
- 巧妙利用三招保护局域网中的 IP 地址
- 局域网之php项目IP访问共享
- ip routing&no ip routing
- Fiddler显示IP的设置方法